Epoxy Floor Coating EP100

EP100 EPOXY DPM is a two-component epoxy resin membrane that is tolerant of residual moisture in concrete floors. This  enables earlier access onto the floor for the application of screeds, coatings and other floor coverings including carpets, tiles, vinyl and wood.

Advantages

• Enables resin finishes etc. to be applied onto new concrete much sooner than the normal time required for concrete to dry.
• Easily applied by brush, roller or trowel edge.
• Can be applied onto substrates with hygrometer readings up to 97% RH.
• Solvent free and low odour

Where to Use

EP100 EPOXY DPM can be used on concrete floors and fine concrete screeds, of not less than 50mm thick, in the case of unbonded screeds. The surface must be of sufficient quality, continuity and mechanical strength to ensure even coating.

The product may also be applied to polymers, screeds and certain types of smoothing underlayments, provided these are well bonded. Such under-layments must be stable to the effects of water. If not the concrete floor must contain an integral damp-proof membrane to prevent further ingress of water from the ground.

Where laid onto a concrete surface where there is no DPM or where damage may have rendered the DPM ineffective due consideration must be given to the possible presence of hydrostatic pressure, and the consequences of creating a barrier layer resulting in the pressure /water flow being directed elsewhere.

EP100 EPOXY DPM has good resistance to mild chemical attack but is designed to be overcoated with other resin finishes.

Downloads

EP100 EPOXY DPM PRODUCT GUIDE May 2009