Thixotropic Epoxy Adhesive

Thixotropic Epoxy Adhesive

Description

DESCRIPTION

THIXOTROPIC EPOXY ADHESIVE is a two part, non-slump gel adhesive, designed to bond materials together or to inject into cracks, fissures and holes. THIXOTROPIC EPOXY ADHESIVE can be injected from a standard 400cc cartridge or applied directly from the mixing pot in a film as thin as 0.2mm.

THIXOTROPIC EPOXY ADHESIVE does not contain solvent or water, so can be applied to difficult substrates.

TYPICAL USES

For bonding timber, stone and metal and for injecting into cracks and holes in timber and masonry. For bonding dowels into timber and masonry.

For laminating timbers and repairing Glulam beams.

PREPARATION AND METHOD

Cut out all rotted, loose or flaking material and vacuum to remove dust. Abrade or grind as necessary to provide clean, stable surfaces free of all contaminants.

Mix the two components thoroughly with a stiff, square edged pallet knife until the two colours blend into an even
colour.

Approximate spreading ‘open’ time is 5 - 10 minutes at 15 - 20 degrees centigrade, initial set in 1 - 2 hours. Initial cure minimum 12 hours, full cure 5 -7 days.

Either apply the adhesive to both surfaces to be bonded, or dispense into a cartridge kit for injection. Ensure that the temperature is above 5 degrees Centigrade, or pre-warm the materials, otherwise curing may be delayed or prevented.

Purchasing Information

Product Codes: TRTEA

Pack Size: 400cc

Page updated 25th Oct 2016, 14:40
  • Video
  • CPD Seminars
  • Downloads
  • The Children’s Air Ambulance
  • Basement Waterproofing Association
BRICK | instant websites
Web design by Brick technology Ltd.